I may still grab a hyper 212 cooler, who knows. Under full load, which was basically running Intel Burn test for 10 passes, the CPU got to just under 72C. Note that I'm not using a fan controller and j have the CPU fan set to run 100% in bios at all times. My idle temps according to Ryzen Master are going as low as 28.4 C. I have 3 fans for intake in front, 2 on top that I use for exhaust, and one in the back that I use for exhaust. Keep in mind, I have the cooler master mb511 case. If you have the cooler mounted with the AMD logo on the top left side, the switch is on the bottom of the cooler on the right. However was getting slightly higher temps on my Rythan I would like.įound by some checking online however that the wraith prism and I'm going to surmise the wraith max, apparently have a fan switch that is located on the bottom right side of the cooler. But I'd purchased a wraith prism cooler as I thought the rgb would look cool etc.

I was not until tonight as I've been pondering adding a different cooler to my system. I hope this cleared up some confusion.Just so everyone is aware. I can even control the colors from my MSI motherboard software.

In my case, I had downloaded the wrong version of the driver software. It took me a while to figure it out, but once I had the above setup, the software worked. Each driver version is only looking for the model of cooler it is tailored for, so make sure that in your case, you download and run the WRAITH PRISM software. For instance, you cannot use Wraith Prism software with a Wraith Max cooler. The software you use should match the model of Wraith cooler you have.The cooler can ONLY be connected to a standard USB 2.0 header. FYI, I'm guessing the AMD USB HEADER on your motherboard is proprietary and is not compatible with this cooler.In this state, the software will not be able to communicate with the cooler. If the RGB wire is connected, the controller will default to using the RGB control and USB control will be turned off. For color control, however, ONLY the USB wire should be connected to a USB 2.0 header. Of course, for fan control, the fan header should always be connected to the CPU fan control header on the motherboard.There are two conditions that must be met in order for the Wraith software to work:

Amd prism cooler rgb control